Crie caixas e muito mais com uma cortadora a laser!
Shelf for holding (multiple) piles of playing cards / notes
ângulo interno dos pés
height of strips to be glued to the inside of bottom edges (multiples of thickness)
height of the feet (multiples of thickness)
distance from finger holes to bottom edge (multiples of thickness)
width of the feet (multiples of thickness)
the angle of arc cuts
the gap between grooves (fraction of the edge length)
alternate the direction of grooves
invert the groove directions
minimum space left and right without grooves (fraction of the edge length)
the style of grooves
the angle of triangular cuts
the width of each groove (fraction of the edge length)
style of the fingers
space at the start and end in multiple of normal spaces
height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!
space below holes of FingerHoleEdge (multiples of thickness)
extra material to grind away burn marks (multiples of thickness)
width of the fingers (multiples of thickness)
extra space to allow finger move in and out (multiples of thickness)
space between fingers (multiples of thickness)
width of finger holes (multiples of thickness)
sections left to right in mm 🛈
profundidade interna em mm (a menos que a opção de medida externa esteja selecionada)
altura interna em mm (a menos que a opção de medida externa esteja selecionada)
treat sizes as outside measurements 🛈
backward angle of floor
make holders stackable
thickness of the material (in mm) 🛈
burn correction (in mm)(bigger values for tighter fit) 🛈
format of resulting file 🛈
label the parts (where available)
print reference rectangle with given length (in mm)(zero to disable) 🛈
width of tabs holding the parts in place (in mm)(not supported everywhere) 🛈
Add a QR Code with link or command line to the generated output
style for inner corners 🛈
spacing around parts (multiples of thickness [: extra space in mm]) 🛈
print surrounding boxes for some structures 🛈
Gerar Download Save to URL QR Code
